Matco dt4 battery4/6/2023 ![]() Used to analyze the health status of the automobile battery, calculate the actual cold starting ability of the battery, judge the aging degree of the battery, and provide reliable analysis basis for the test and maintenance of the battery. After pairing, it can be used normally.In the pop-up Bluetooth list, select the Bluetooth name (starting with MAXBATTERYxxx) of the battery tester to be paired.First, clamp the BLACK and RED clips of the battery tester on the Negative (-) and Positive (+) terminals of the vehicle battery respectively.Due to continuing improvements, the actual product may differ slightly from the product described herein, and this User Manual is subject to change without notice. Note: Pictures illustrated here are for reference purposes only. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Increase the separation between the equipment and receiver.Reorient or relocate the receiving antenna.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. (2)This device must accept any interference received, including interference that may cause undesired operation. (1)This device may not cause harmful interference, and Operation is subject to the following two conditions: This device complies with Part 15 of the FCC Rules. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. ![]() Minnesota state franchise registration number F-2705.If you have any questions on the operation of the tool, please contact Matco customer service number: 87. If you are a resident of, or wish to acquire a franchise for a to be located in, one of these states or a country whose laws regulate the offer and sale of franchises, we will not offer you a franchise unless and until we have complied with applicable pre-sale registration and disclosure requirements in your jurisdiction. ![]() Currently, the following states regulate the offer and sale of franchises: California, Hawaii, Illinois, Indiana, Maryland, Michigan, Minnesota, New York, North Dakota, Oregon, Rhode Island, South Dakota, Virginia, Washington, and Wisconsin. An offer is made only by Franchise Disclosure Document (FDD). This information is not intended as an offer to sell, or the solicitation of an offer to buy, a franchise. ![]() Ranked by Entrepreneur Magazine, Tools Distribution Category years 2007, 2008, 2010, 2011, 2012. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |